"I used to ski way back, but now I have carpenter's knees," says Norm Abram, master carpenter, native New Englander and a star of television's This Old House for more than 25 years. Abram may have retired from the slopes, but he remembers how awkward it can be to store skis—they're long, they're sharp and their bulky bindings protrude in the wrong places. "We used to lay our skis up across the joists in the ceiling of the garage," he recalls, a good solution only if your garage ceiling happens to have exposed joists. Drawing on his background as a skier and a homeowner—not to mention his considerable genius with the table saw—Abram designed an easy, do-it-yourself rack especially for Skiing, similar to one he once built in his own garage. It'll hold skis of all sizes and shapes, out of the way but easily accessible. Best of all, you don't have to be Norm Abram to build it.
- Two 2x4s, each about 6 feet long (good for four pairs of skis)
- 6 feet of 3/4-inch dowel
- A few 3-1/2-inch drywall screws
- Two 4-foot lengths of Armorflex pipe insulation, to fit over dowel
- Latex caulk
- Exterior-grade paint
- 3/4-inch drill bit
- Chamfer routing bit
- Heavy-duty shears (to cut Armorflex)
- Caulk gun
- Bevel gauge
- Fine sandpaper
- Tape measure
Click on the slideshow below to see the supplies and tools you will need. With the 4-inch sides of the 2x4s facing you, chamfer and sand the two vertical front edges. Used on a regular drill, a chamfer routing bit creates a uniform beveled edge. Paint the wood to protect it against moisture.
Divide the length of the 2x4s by the number of skis you plan to store, and mark them with a pencil at appropriate, evenly spaced intervals. Example: If you have four pairs of skis, make a mark every 15 inches on each 2x4. If you're only storing two pairs, cut the 2x4s in half, which will still leave ample room to create rests for two pairs of skis. "You just have to make sure there's enough space between them that the binding on one ski won't hit the one above it," Abram says. Using a bevel gauge to guide the drill bit into the wood at a slight angle, drill holes for the dowels where marked (see more here). Drill 1- 1/4-inches deep with the 3/4-inch bit.
Give It a Rest
Cut the dowels into 6-inch lengths and sand one tip of each piece. Insert the dowel lengths (sanded side out) into the holes in the 2x4s and apply a bead of latex caulk around the base of each. Cover each dowel with Armorflex. Your skis will lie across these pegs. "The Armorflex will provide a nice, soft cushion," says Abram.
Hang 'Em Up
Choose an empty wall in your garage or basement where the skis will hang. You'll need a spot where you can attach the 2x4s to the wall parallel to each other and far enough apart so that the dowels become shelves for the skis. You can mount them out of the way, or close to the floor for easy access. Screw the 2x4s into the wall. "In the garage, most walls are finished with drywall, so you'll have to find two studs," says Abram. (Studs are typically 32 or 48 inches apart.) The 2x4s should be 3 to 4 feet apart—far enough so that the dowels won't interfere with bindings, but with plenty of clearance between the dowel "rests" and the tips of your skis. Use a level to make sure the 2x4s are hung so that the skis will rest exactly horizontally.